Underground Injection Control Program

Injection wells are used as a means to dispose of or store fluids in the subsurface. In Idaho, excess stormwater, agricultural water, and facility heating/cooling water are the most common fluids disposed of with injection wells of various design, including standard cased well, drain fields, infiltration trenches.


The Underground Injection Control (UIC) program was delegated by EPA to the Idaho Department of Water Resources (IDWR) in 1985. The Idaho Department of Water Resources (IDWR) regulates the construction, operation, and abandonment of all injection wells through the Idaho Underground Injection Control Program. A majority of the wells currently managed by the IDWR UIC program are storm water, agricultural return flow, and heat exchange systems.


The construction and use of large-capacity cesspools and motor vehicle waste disposal wells (MVWDW) is prohibited in Idaho. The Environmental Protection Agency (EPA) mandated that existing large-capacity cesspools and MVWDW be decommissioned by April 2005. For more information contact the IDWR Underground Injection Control Program.


Injection wells can directly or indirectly cause negative impacts to groundwater resources. The well owner/operator may incur considerable costs for mitigation, cleanup, and legal fees in the event that subsurface contamination is caused through the operation of an injection well. An injection well permit does not release the well owner and/or operator from liability. IDWR encourages permanent closure of injection wells wherever practical.


Injection wells in Idaho are categorized into two types: 1) deep injection wells are greater than 18 feet deep, and 2) shallow wells are less than 18 feet deep. Both types of injection wells are regulated under Idaho Code Title 42 Chapter 39 and IDAPA 37.03.03.


Deep Injection Wells
Shallow Injection Wells

Public Notice - Draft Injection Well Permits